The full featured Windows programming interface supports baseline (PIC10F, PIC12F5xx, PIC16F5xx), midrange (PIC12F6xx, PIC16F), PIC18F, PIC24, dsPIC30, dsPIC33, and PIC32 families of 8-bit, 16-bit, and 32-bit microcontrollers, and many Microchip Serial EEPROM products.With Microchips powerful MPLAB Integrated Development Environment (IDE) the PICkit2 Lite enables in-circuit debugging on most PIC microcontrollers.
Pickit2 'Uart Tool Full Featured WindowsIn-Circuit-Debugging runs, halts and single steps the program while the PIC microcontroller is embedded in the application. When halted at a breakpoint, the file registers can be examined and modified. The programmer is fully compatible with wide range of prototype boards (for example PIC-P18, PIC-P28, PIC-P40). Power supply voltage can varies in range 2.5V.5V with 0.1V step. The PICkit 2 connects via the ICSP connector directly to microcontroller TX and RX pins at logic levels. The Logic IO mode is useful for triggering inputs to a PIC microcontroller or other digital circuitry, and can monitor digital signals to display their state. In essence, it provides an alternative for wiring buttons and LEDs to pins or signals while debugging or developing IO functions. The Analyzer mode can display waveforms of up to 3 digital signals, and trigger on specific events such as a rising edge on one signal when another signal is at a logic high level. This may be very useful for debugging serial communication buses such as UART, SPI, and I2C. It is also very applicable to monitoring the behavior of general microcontroller IO. This functionality allows a PIC MCU memory image to be downloaded into the PICkit 2 unit for later programming into a specific PIC MCU. Pickit2 'Uart Tool Software Or PCNo software or PC is required to program devices once the PICkit 2 unit is set up for Programming-To-Go.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |